Al Full-Tension Joint Oval Section DIN 48201

Description

For Al conductors 1-10KV Al conductors according to DIN 48201

Material

Al 99.5

Surface:

Uncoated

Cat. No.	Conductor Cross Section sq. mm	Conductor Diameter Ø mm	Die Code No.	No. of Compressions	Dimensions mm			Weight 100 Pcs. Kg.
					d1	d2	l
101301299	25	6.3	16PO	6	14	7.0	112	2.0
101301300	35	7.5	18PO	7	16	8.0	126	2.4
101301301	50	9.0	20PO	10	19.5	10.0	180	4.2
101301302	70	10.5	22PO	15	22.5	11.5	198	5.6
101301303	95	12.5	24PO	15	26.5	13.5	264	10.9
101301304	120	14.0	26PO	15	30.0	15.0	286	13.5

 User Instructions:

The compression joints are marked with a code number in front of the logo (roughly corresponding to the outer diameter of the compression sleeve). The required compression die is selected in accordance with this code number. For hexagonal compressions made with hand-operated mechanical compression tools, browned dies (black) are to be used for copper, bronze and steel compression joints, whereas aluminium compression joints require electro-galvanized dies (white). For hydraulic compression tools there is no differentiation of dies for different metals. The compression sleeve non-tension and full-tension of aluminium compression joints and of full-tension copper compression joints are prefilled with compression compound which must not be removed before the compression, neither completely nor in part. Any compression compound escaping during the compression should be wiped off.

Assembly Instructions:

1. Clean the conductor or cable ends with a wire brush to remove dirt and oxidation.
2. Insert conductor or cable ends into the compression sleeve up to the centre.
3. Before proceeding, make sure that the code number on the compression joint is matched to that on the compression die.
4. Compression joints are compressed by making the first compression at the centre and working out toward the ends. The number of compressions is marked on the sleeve. It is important to make the specified number of compressions.

Diagram: