Cu Non-Tension Compression Joint

Description

Material:

Copper: E-Cu

Surface:

Tin-plated

Cat. No. Conductor Cross-
Section sq. mm Conductor
Ø mm Dimensions mm Weight
100 pcs.

d l

101303891 6 3.2 3.8 15 0.24

101303892 10 4.05 4.5 20 0.25

101303893 16 5.1 5.5 20 0.49

101303894 25 6.3 6.8 32 0.89

101303895 35 7.5 8.2 36 1.48

101303896 50 9.0 9.5 40 2.09

101303897 70 10.5 11.0 40.5 3.25

101303898 95 12.5 13.5 45 4.10

101303899 120 14.0 15.0 46 6.70

101303900 150 15.7 16.0 55 6.91

101303901 185 17.5 18.0 60 8.50

101303902 240 20.2 21.0 80 14.11

Cat. No.	Conductor Cross- Section sq. mm	Conductor Ø mm	Dimensions mm	Weight 100 pcs.
			d	l
101303891	6	3.2	3.8	15	0.24
101303892	10	4.05	4.5	20	0.25
101303893	16	5.1	5.5	20	0.49
101303894	25	6.3	6.8	32	0.89
101303895	35	7.5	8.2	36	1.48
101303896	50	9.0	9.5	40	2.09
101303897	70	10.5	11.0	40.5	3.25
101303898	95	12.5	13.5	45	4.10
101303899	120	14.0	15.0	46	6.70
101303900	150	15.7	16.0	55	6.91
101303901	185	17.5	18.0	60	8.50
101303902	240	20.2	21.0	80	14.11

User Instructions:

The compression joints are marked with a code number in front of the logo (roughly corresponding to the outer diameter of the compression sleeve). The required compression die is selected in accordance with this code number. For hexagonal c ompressions made with hand-operated mechanical compression tools, browned dies (black) are to be used for copper, bronze and steel compression joints, whereas aluminium compression joints require electro-galvanized dies (white). For hydraulic compression tools there is no differentiation of dies for different metals. The compression sleeve non-tension and full-tension of aluminium compression joints and of full-tension copper compression joints are prefilled with compression compound which must not be removed before the compression, neither completely nor in part. Any compression compound escaping during the compression should be wiped off.

Assembly Instructions:

Clean the conductor or cable ends with a wire brush to remove dirt and oxidation.
Insert conductor or cable ends into the compression sleeve up to the centre.
Before proceeding, make sure that the code number on the compression joint is matched to that on the compression die.
Compression joints are compressed by making the first compression at the centre and working out toward the ends. The number of compressions is marked on the sleeve. It is important to make the specified number of compressions.