Al/Cu Bimetallic Compression Joint up to 10 kV - According to DIN

Description

For non-tension connection of aluminium conductors to copper conductors

Material

Aluminium Part:

Al 99.5

Copper part:

E-Cu

Surface:

Uncoated. Al compression joints are pre-filled with compression compound and sealed with plastic caps. Sector shaped conductors must be rounded with round-forming dies before compression.

Cat. No.	Conductor Cross-Section
	Al	Cu
101301059	16	6
101301064	16	10
101301065	16	16
101301061	25	6
101301062	25	10
101301066	25	16
101301067	25	25
101301141	25	50
101301068	35	6
101301069	35	10
101301070	35	16
101301071	35	25
101301072	35	35
101301075	50	10
101301076	50	16
101301077	50	25
101301078	50	35
101301079	50	50
101301148	50	95
101301149	50	150
101301074	70	10
101301080	70	16
101301081	70	25
101301082	70	35
101301083	70	50
101301084	70	70
101301144	95	6
101301142	95	10
101301085	95	16
101301086	95	25
101301087	95	35
101301088	95	50
101301089	95	70
101301090	95	95
101301091	120	16
101301092	120	25
101301093	120	35
101301094	120	50
101301095	120	70
101301096	120	95
101301097	120	120
101301063	120	150
101301098	150	16
101301099	150	25
101301100	150	35
101301101	150	50
101301102	150	70
101301103	150	95
101301104	150	120
101301105	150	150
101301146	185	25
101301106	185	35
101301107	185	50
101301108	185	70
101301109	185	95
101301110	185	120
101301111	185	150
101301112	185	185
101301123	240	50
101301124	240	70
101301125	240	95
101301113	240	120
101301114	240	150
101301115	240	185
101301116	240	240
101301120	240	300
101301145	300	70
101301122	300	95
101301121	300	150
101301119	300	185
101301117	300	240
101301118	300	300

 

User Instructions

The compression joints are marked with a code number in front of the logo (roughly corresponding to the outer diameter of the compression sleeve). The required compression die is selected in accordance with this code number. For hexagonal compressi   ons made with hand-operated mechanical compression tools, browned dies (black) are to be used for copper, bronze and steel compression joints, whereas aluminium compression joints require electro-galvanized dies (white). For hydraulic compression tools there is no differentiation of dies for different metals. The compression sleeve non-tension and full-tension of aluminium compression joints and of full-tension copper compression joints are prefilled with compression compound which must not be removed before the compression, neither completely nor in part. Any compression compound escaping during the compression should be wiped off.

Assembly Instructions

1. Clean the conductor or cable ends with a wire brush to remove dirt and oxidation.
2. Insert conductor or cable ends into the compression sleeve up to the centre.
3. Before proceeding, make sure that the code number on the compression joint is matched to that on the compression die.
4. Compression joints are compressed by making the first compression at the centre and working out toward the ends. The number of compressions is marked on the sleeve. It is important to make the specified number of compressions.

Diagram: